An external auto switching 100/240VAC - 2.5A at 24V 
power supply allows an electronic circuit to provide, through the tension arm, the adjustment of the rotation’s speed and rotation’s direction.
A 2A fuse is used as protection. The Label Rewinder "All-in-one" has two types of speed adjustments, through a knob it is possible to decide the maximum speed while the tension arm adjusts the speed from zero up to the maximum speed selected and the sense of rotation.
When the printer forwards the media for printing, the tension arm goes down, the Rewinds the media.
When the tension arm is in the middle position, the device is idle.
When the printer pulls back the media, the tension arm goes up, the "All-In-One" unwinds it.
When the roll of labels runs out, the all-in-one unwinder stops by uttering an acoustic signal.
The obtained roll of labels will have the labels face out only.
Label Rewinder "All-in-one" Series is available in different versions and every model is marked by its own code. Through the configuration table below, it is possible to select the version better fitting your needs and to obtain the code of the product to order.
The support can be added later on. On the 244mm (9.60") label width the support is required whereas on the 174mm (6.85") the support is suggested; If the unit is equipped with support, the core holder is adjustable from 46mm (1.81") up to 118mm (4.64").
Brochure | User Manual |
CONFIGURATION| TYPE | ROLL
DIAMETER | SPEED | LABEL WIDTH | CORE HOLDER | SUPPORT |
|---|
ASD
Rw "All in one" | 1
250mm (10") | 1
120 rpm | 1
127mm (5") | 1
40mm - 118mm
(1.57" - 4.64") | S0
Without support |
| 2
300mm (11.81") | 2
225 rpm | 2
174mm (6.85") | 4
76mm (3") fixed | S1
Roll diameter 250mm (10") |
| | | 3
244mm | | S2
Roll diameter 300mm (11.81") |
| | | | | S4
76mm (3") Fixed core holder |
Configuration example: ASD 1 1 1 1 - S1
CORE HOLDER| 40-118mm CORE HOLDER | 3" FIXED CORE HOLDER |
|---|
 |  |
GALLERY
